I have no knowledge about standard architectural scales in the imperial world (US), so i choose 1:96 as it's closest to metric standard 1:100. Some time ago I have tried to make a template for architecture in inches as unit. Except for "Fixed Length" extension lines if you use that, these sadly do not respond to "General Scale". You don't have to change the other values any more. It is best to make yourself a template with the dimensioning settings you like, and then use it for future new drawings andĪdjust to a different scale with "General Scale". Oh – if I modify the block that is in the block list, will all blocks update by any chance?Īs you do architectural drawings you will have a much smaller scale, and you can see the proper look only in the print preview mode. As long as open source, if they work, I will supply them.Īll I need is an architectural set of fixtures! There are a couple of fonts I may experiment with. The gap for the dimension text is almost correct, but should be a bit wider as it actually touches the number on the left side and looks correct on the right side only because the “ for inches is above the center so the line doesn’t touch No matter how I set scales for Arrow/Tick Line Thickness, the ticks are still skinny. In drawing mode or print preview, there are still a few things that could be nicer, but I can live with this. Setting overall dimension scale to 1 and setting the other values worked much better. A lot of residential is on C while small commercial is often D and large commercial would be E. Typical scales would be 1/8” = 1’ or 1/4” = 1’ (1:96 and 1:48).ĭepends a bit on the size of the job. (18x24, 24x36, and 36x48 for architectural – engineering is slightly smaller based on multiples of 8.5x11). You may play with this.Īrchitectural drawings (ANSI) are typically either C, D or E size. I have tried it out prior to writing this and got an error "freetype6.dll not found", but I remember to have had it working some time ago. If you take a quite "sticky" font it might look acceptable. With this you can turn a windows ttf font to a LC lff font. Maybe you could make a template for other American fellows, there often are questions on that in the forum.Īrch_inch_1_96_letter.dxf Concerning fonts, in the main LibreCAD program folder there is a ttf2lff.exe. I include it here so you may have a look at it. It is best to make yourself a template with the dimensioning settings you like, and then use it for future new drawings and adjust to a different scale with "General Scale". Line thickness is shown right on screen in drawing mode only at a scale of 1:1.Īs you do architectural drawings you will have a much smaller scale, and you can see the proper look only in the print preview mode. Any more typical settings than the default which leaves text and arrows and so on so small you can’t see that they exist? I started with a general scales of 10 and then modified the individual values. But changing the tick size does indeed change the length. – even a very large value for text, dimension lines, or ticks seems to have no effect. In dimensioning, overriding the width options from “by layer” to a value I would prefer an older style “hand drawn” font and the ability to bold it or something (same goes for normal text). Wish there was a better selection of fonts. And I have tried both horizontal and aligned. It doesn’t “break” or give a gap for the text no matter what settings I try. The dimension line still goes through the text. So – It is very close to what I am trying to accomplish. And doing the offset for text – “minus height / 2” positions it correctly. I have indeed set an appropriate tick size and zero arrow size.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |